To Next Page

To Previous Page

3-12 Remote Operation Model 6517A Getting Started Manual

Function conﬁguration

[:SENSe[1]] SENSe Subsystem

:FUNCtion <name> Select measurement function:

<name> = 'VOLTage[:DC]' Volts function

'CURRent[:DC]' Amps function

'RESistance' Ohms function

'CHARge' Coulombs

function

:VOLTage[:DC] Path to conﬁgure volts:

:NPLC <n> Set speed: 0.01 to 10 PLC.

:AUTO Enable or disable auto NPLC.

:RANGe Path to conﬁgure measurement range:

[:UPPer] <n> Specify expected reading to select range.

:AUTO <n> Enable or disable auto range.

:REFerence <n> Specify reference (rel): -210 to +210.

:STATe Enable or disable reference (rel).

:ACQuire Use input signal as reference (rel).

:DIGits <n> Specify measurement resolution.

:AUTO Enable or disable auto resolution.

AVERage Path to control digital ﬁlter:

:TYPE <name> Select ﬁlter (NONE, SCALar or ADVanced).

:TCONtrol <name> Select averaging method (REPeat, or

MOVing).

:COUNt <n> Specify ﬁlter count (1 to 100).

:ADVanced Path to conﬁgure advanced ﬁlter:

:NTOLerance <n> Specify noise tolerance (0 to 100%).

[:STATe] Enable or disable digital ﬁlter.

:MEDian Path to control median ﬁlter:

:RANK < n> Specify rank for ﬁlter (1 to 5).

[:STATe] Enable or disable median ﬁlter.

:GUARd Enable or disable guard.

:CURRent:DC Path to conﬁgure Amps:

(Volts commands) The commands for Volts (except :GUARd)

apply.

:DAMPing Enable or disable damping.

Keithley 6517A Getting Started Guide

Other manuals for Keithley 6517A