Remote Controller
For
KVT-534DVD
:
This
unit
can
be
operated
using
the
Remote
Controller
supplied
with
this
unit.
For
KVT-514:
Optional
Remote
Controller
KNA-RCDV330
is
designed
for
controlling
this
unit.
it
•
Put
the Remote Controller
in
a place where
it
will
not
move during braking or other operations. A dangerous situation could
result.
if
the Remote Controller falls
down
and gets wedged under the pedals while driving.
• Do
not
place the battery near
an
open flame or heat source. This may cause the battery
to
explode.
• Do
not
recharge, short. break
up
or heat the battery or place it in
an
open fire.
Such
actions may cause the battery
to
leak
fluid. If spilled fluid comes in contact
with
your
eyes
or on clothing, immediately rinse
with
water and consult a physician.
•
Place
the battery
out
of
reach
of
children.
In
the
unlikely event that a child swallows the battery, immediately consult a
physician.
ACAUTION
• Do
not
leave the battery near fire or under direct sunlight. A
fire,
explosion or excessive heat generation may result.
Battery installation
Remote Controller mode switch
Use
two
IAAA"/"R03"-size
batteries.
Insert
the
batteries
with
the +
and
-
poles
aligned
properly,
following the
illustration
inside
the
case.
The
functions
operated
from
the
remote
controller differ depending
on
the
position
of
the
mode
switch.
AUDmode
Switch
to
this
mode
when
controlling a selected source
or tuner source, etc.
Not used
AUD·
DVO
..
··i---DVD
mode
TV-
Switch
to
this mode when
playing
DVDs
or
CDs
etc.
with the player integrated in
this unit.
~
~
If the Remote Controller operates only over shorter
distances or does
not
operate at
all,
it
is
possible that
the batteries
are
depleted.
In
such instances, replace the
both
batteries
with
new
ones.
~
~
• The position
of
the remote control mode switch
is
indicated in the title
of
each mode,
e.g.,
"(AUD mode)".
When controlling a player that
is
not
integrated in the
unit, select
"AUD"
mode.
92
•
KVT-514/KVT-534DVD
To Next Page
Loading...
Need help?
General
