693
Driving your vehicle
To drive over the preset speed limit
you must depress hard on the accel-
erator pedal (more than approxi-
mately 80%) until the kick down
mechanism works with a clicking
noise. Then the set speed limit will
blink and chime will sound until you
return the vehicle speed within the
speed limit.
✽✽
NOTICE
• Depressing the accelerator pedal
less than approximately 50%, the
vehicle will not speed over the pre-
set speed limit but maintain the
vehicle speed within the speed
limit.
• A clicking noise heard from the
kick down mechanism by depress-
ing the accelerator pedal fully is a
normal condition.
To turn off the speed limit con-
trol, do one of the following:
• Press the speed limit
switch once again.
• Press the cruise switch (If you
press cruise switch, the cruise sys-
tem will turn on)
If you press the O switch once, the
set speed limit will cancel, but it will
not turn the system off. If you wish to
reset the speed limit, move the lever
up (to RES+) or down (to SET-) to
the desired speed.
OJF058153L
OBD058019R
To Next Page
Loading...
Need help?
General
