What to do in an emergency
226
Distributing the sealant
12. Immediately drive approximately
7~10km (4~6miles or, about
10min) to evenly distribute the
sealant in the tyre.
Checking the tyre inflation
pressure
1. After driving approximately 7~10
km (4~6 miles or about 10 min-
utes), stop at a suitable location.
2. Connect the filling hose (3) of the
compressor (clip mounted side)
directly and then connect the filling
hose (3) (opposite side) to the tyre
valve.
3. Connect between compressor and
the vehicle power outlet using the
cable and connectors.
CAUTION
Do not exceed a speed of 60
km/h (35 mph). If possible, do
not fall below a speed of 20
km/h (12 mph).
Whilst driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road. Call for
road side service or towing.
When you use the Tyre Mobility
Kit, the tyre pressure sensors
and wheel may be stained by
sealant. Therefore, remove the
tyre pressure sensors and
wheel stained by sealant and
have the vehicle inspected at a
professional workshop. Kia rec-
ommends to visit an authorised
Kia dealer/service partner.
OTAM061030
To Next Page
Loading...
Need help?
General
