10.21
Section 10
Reassembly
10
Figure 10-77. Installing Air Cleaner Cover.
Install Muffler
1. Install the gasket, muffler, and hex. flange nuts on
the exhaust port studs. Leave the nuts slightly
loose.
2. If an auxiliary muffler bracket is used, install the
M6 hex. flange screw(s) into the bracket.
3. Torque the hex. flange nuts to 24.4 N·m
(216 in. lb.). See Figure 10-78. Torque the screws
to 7.5 N·m (65 in. lb.).
Figure 10-76. Installing Precleaner.
3. Install the air cleaner cover and secure with the
two retaining knobs. See Figure 10-77.
Figure 10-78. Torquing Exhaust Flange Nuts.
Install Drain Plug, Oil Filter, and Oil
1. Install the oil drain plug and torque to 14 N·m
(125 in. lb.).
2. Place a new replacement filter in a shallow pan
with the open end up. Pour new oil of the proper
type, in through the threaded center hole. Stop
pouring when the oil reaches the bottom of the
threads. Allow a minute or two for the oil to be
absorbed by the filter material.
3. Put a drop of oil on your fingertip and wipe it onto
the rubber gasket. Thread the filter onto the
engine until the rubber gasket contacts the
surface, then tighten the filter an additional 2/3-1
turn. See Figure 10-79. Fill the crankcase with
new oil of the proper type, to the “F” mark on the
dipstick.
Figure 10-79. Installing Oil Filter.
Not For Resale
www.SmallEngineDiscount.com
To Next Page
Loading...
Need help?
General