SAFETY, NOISE AND VIBRATION PLATES
18
2.1 SAFETY, NOISE AND VIBRATION PLATES
2.1.1 POSITION OF THE SAFETY PLATES
• The safety plates must always be legible and in good conditions; for this reason, if they are dirty with dust, oil or
grease, it is necessary to clean them with a solution made of water and detergent.
Do not use fuel, petrol or solvents.
• If the plates are damaged, ask for new ones to Komatsu Utility or to your Komatsu Utility Dealer.
• In case of replacement of a component provided with a safety plate, make sure that this plate is applied also on
the new piece.
• The machine can be provided with other plates in addition to those indicated below; keep also to the instructions
given in the additional plates, in any case.
RYA14780
To Next Page
Loading...
Need help?
General
