2-74
PC130/150LGP-6K ENG
12.OPERATION
12.14 HOW TO ESCAPE FROM MUD
Always operate carefully to avoid getting stuck in mud. If the machine
does get stuck in mud, use the follwoing procedures to get the machine
out.
12.14.1 WHEN ONE SIDE IS STUCK
When only one side is stuck in mud, use the bucket to raise the track,
then lay boards or logs and drive the machine out. If necessary, put a
board under the bucket also.
NOTICE
When using the boom or arm to raise the machine, always have
the bottom of the bucket in contact with the ground. (Never push
with the teeth). The angle between the boom and arm should be 90°
to 110°.
The same applies when using the inverting bucket.
12.14.2 WHEN BOTH SIDES ARE STUCK
When the tracks on both sides are stuck in the mud and the machine
will not move, lay boards as explained above, and dig the bucket into the
ground in front. Then pull in the arm as in normal digging operations an
put the travel levers in the FORWARD position to pull the machine out.
To Next Page
Loading...
Need help?
General
