2-81
PC130/150LGP-6K ENG
12.OPERATION
12.20 CHECK AFTER STOPPING ENGINE
1. Walk around the machine and check the work equipment, paintwork,
and undercarriage, and check also for leakage of oil or water, if any
abnormalities are found, repair them.
2. Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean out any
paper and debris to avoid a fire hazard.
4. Remove any mud stuck to the undercarriage.
12.21 LOCKING
Always lock the following places
Door of operator's cab
Always remember to close the window.
Fuel tank filler port
Engine hood
Tool box cover
Battery room door (left side of machine)
Pump room door (right side of machine)
REMARK
Use the starting switch key to open and close all these places.
To Next Page
Loading...
Need help?
General
