HANDLE BUCKET WITH HOOK
When
using the bucket with hook, check that there is no damage to the hook, stopper, or hook mount. If there is
any problem, ask your Komatsu distributor.
PRECAUTIONS FOR OPERATION
PRECAUTIONS FOR LIFTING OPERATION
• If lifted load largely swings, it is dangerous.
Lower the engine speed and operate the work equipment
control lever slowly.
• The swing speed of this machine is 3 to 4 times the speed
of a mobile crane.
Be careful to check that the area around the machine is
safe when performing the swing operation.
• Depending on the posture of the work equipment, there is
a danger that the wire or load may slip off the hook. Al-
ways be careful to maintain the correct hook angle to pre-
vent the slipping-off.
• Never drive the machine while lifting a load.
• If the bucket with hook is turned 180° and used for opera-
tions, it will interfere with the arm during the bucket DUMP
operation. Be careful when using it.
• During sling work, do not swing the boom or offset it.
Align the direction of the boom to the center.
• If you are planning to newly install a hook, ask your Ko-
matsu distributor for installation.
HANDLE BUCKET WITH HOOK ATTACHMENTS AND OPTIONS
6-4
To Next Page
Loading...
