METHOD FOR CHECKING AFTER FINISHING WORK
Perform it after stopping the engine.
1.
Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check
for any leakage of oil or coolant. If any problems are found, repair them.
2.
Fill the fuel tank.
3.
Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4.
Remove any mud affixed to the undercarriage.
LOCK
Always lock the following places.
REMARK
Use the starting switch key to lock and unlock all these places.
Lock
positions for the machine with canopy
specification
(1) Toolbox for tools and Operation and Maintenance Manual
(2) Dirt cover
(3) Engine rear cover
OPERATION MACHINE OPERATIONS AND CONTROLS
3-199
To Next Page
Loading...
Need help?
General
