PRECAUTIONS WHEN GETTING ON OR OFF MACHINE
USE HANDRAILS AND STEP ON TRACK WHEN GETTING ON OR OFF MACHINE
T
o prevent personal injury caused by slipping or falling off the machine, always observe the following.
• The handrail and track shown with arrows in the figure can be used for getting on and off.
• Machine with canopy specification
• Machine with cab specification
• Always follow the three-point rule for safety. The three-
point rule means three of your four limbs are in contact
with the handrail and track at all times (two hands and one
foot or two feet and one hand).
• Before getting on and off the machine, check the handrails
and tracks if there is any oil, grease, or mud on them.
Wipe it off immediately not to slip if any. If there is any
loose bolt on the handrails, tighten it securely.
If the handrails are damaged or deformed, they need to be
repaired immediately. Ask your Komatsu distributor for that
work.
• Do not grip the control levers or lock lever when getting on or off the machine. At that time, take care that
your body or clothes do not touch the levers.
• Never climb on the engine hood or covers where there are no non-slip pads.
• Do not get on or off the machine with tools in your hand.
NO JUMPING ON OR OFF MACHINE
Getting on or off the moving machine can cause serious personal injury or death. Always observe the following.
• Never jump on or off the machine. Never get on or off a moving machine.
• If the machine starts to move when there is no operator on the machine, do not jump on to the machine and
try to stop it.
NO PEOPLE ON ATTACHMENTS
Never let anyone ride on the work equipment or other attachments. There is a hazard of falling and suffering
serious personal injury or death.
GENERAL PRECAUTIONS COMMON TO OPERATION AND MAINTE-
NANCE SAFETY
2-18
To Next Page
Loading...
Need help?
General
