OPERATION OPERATION
3-92
USING SWITCH TO CHANGE BETWEEN FORWARD AND REVERSE 0.
(If equipped)
1. Place the directional lever at the N position.
2. Turn the directional selector switch actuation switch on the
right switch panel ON.
The pilot lamp inside the switch and the directional selector
pilot lamp on the machine monitor light up.
This actuates the operation of the directional selector
switch.
If the directional selector pilot lamp on the machine monitor
flashes, the switch for the lever is in one of the following condi-
tions. Set it to the correct position.
! When directional lever is not at N position
If the directional lever is not at the N position, the pilot lamp
flashes, and at the same time, the central warning lamp
lights up and the alarm buzzer sounds. In addition, “E00
SHIFTLEVER NEUT“ is displayed on the character display.
In this condition, the machine will move forward or in
reverse according to the set position of the directional lever.
Return the directional lever to the N position.
! When directional selector switch is at F or R when engine is
started
If the directional selector switch is at F or R, the pilot lamp
flashes, and at the same time, the central warning lamp
lights up and the alarm buzzer sounds. In addition, “E00
SHIFT SW NEUT“ is displayed on the character display.
In this condition, the engine will not start, so set the direc-
tional selector switch to N.
3. Press the selector switch on the side of the control lever to
the desired position.
To Next Page
Loading...
Need help?
General
