HANDLING LOAD METER ATTACHMENTS, OPTIONS
6-12
TOTAL LOAD DATA DISPLAY 0.
1. Check that the normal service meter and time are displayed
on the character display.
2. Press the (&) of monitor panel selector switch 1 and display
“LOAD METER“.
3. Press the (&) of monitor panel selector switch 1, then press
the (>) or (<) of monitor panel mode selector switch 2 to dis-
play "DATA".
4. Press the (&) of monitor panel selector switch 1 to display
“TOTAL DATA“.
The time when the load on the bottom line was calculated is
displayed as the hour meter standard.
5. Press the (>) or (<) of monitor panel mode selector switch 2
to select the data for each of A to E or the all lighted-up dis-
play.
To Next Page
Need help?
General
