SAFETY PRECAUTIONS FOR OPERATION
2-23
STARTING WITH BOOSTER CABLES 0.
If any mistake is made in the method of connecting the booster
cables, it may cause the battery to explode, so always do as
follows.
! When starting with a booster cable, carry out the starting
operation with two workers (one worker sitting in the opera-
tor‘s seat and the other working with the battery).
! When starting from another machine, do not allow the two
machines to touch.
! When connecting the booster cables, turn the starting
switch OFF for both the normal machine and problem
machine. There is a hazard that the machine will move
when the power is connected.
! Be sure to connect the positive (+) cable first when installing
the booster cables. Disconnect the negative (-) cable
(ground side) first when removing them.
! When removing the booster cables, be careful not to let the
booster cable clips touch each other or to let the clips touch
the machine.
! Always wear safety goggles and rubber gloves when start-
ing the engine with booster cables.
! When connecting a normal machine to a problem machine
with booster cables, always use a normal machine with the
same battery voltage as the problem machine.
! For details of the starting procedure when using booster
cables, see “STARING ENGINE WITH BOOSTER CABLE
(3-132)“ in the OPERATION section.
To Next Page
Loading...
Need help?
General
