bizhub 225i 6-4
6.1 Overview of PC-Fax
6
6.1.3 Setup procedure
The setup refers to a series of procedures for connecting this machine to the computer and installing the fax
driver to the computer.
Perform the setup using the following procedures.
When updating an existing fax driver, uninstall it first. For details, refer to p. 6-8.
USB connection
1 Connect this machine to the computer using a USB cable.
2 Install the fax driver.
dReference
For details on the USB interface, refer to the [User's Guide Print].
Network connection
1 Connect this machine to the computer.
2 Check that the computer to be used is connected to the network.
3 Specify the IP address of this machine, and then connect it to the network.
4 Change the network settings for this machine according to the connection method or protocol.
% LPR: Select [TCP/IP Configuration] - [LPD Setting], and enable LPD printing.
% Port 9100: Select [IPv4 Configuration], and enable the RAW port number (default: [9100]).
5 Install the fax driver.
% Specify the network port for the fax driver according to the connection method or protocol.
dReference
For details on Ethernet, refer to the [User's Guide Print].
For details on the network settings of the machine, refer to Web Connection - [Network] - [TCP/IP Configu-
ration] and [Network] - [IPv4 Configuration] in [User's Guide Network Administrator].
To Next Page
Loading...
Need help?
General
