Transmission
3
Network Fax 3-15
Transmitting originals by using both the ADF and the platen glass
You can scan originals by using both the ADF and the platen glass and you
can also scan the large amounts of originals by placing them on the ADF in
several times.
1 If the fax screen is not displayed, press [Fax] on the control panel to
open the fax screen.
2 Specify a destination.
3 Set the desired functions as necessary.
4 Place the original on the platen glass.
Press [Scan Setting] - [Separate Scan]
- [OK] and then press [Start].
– Document placed on the ADF will
take precedence over those on the
platen glass.
5 Place the next original on the ADF or the platen glass and press [Start].
– Repeat this procedure until all originals to be sent have been
scanned.
The scanned originals are stored in memory.
6 Press [Finish].
The Document reading mode is canceled.
To Next Page
Loading...
Need help?
General
