Krone EasyCut F 360 Original Operation Instructions

78
15 index
A
Abrasion Limit.....................................................60
Adjusting the Compensation Springs .................42
Adjusting the cutting height ................................43
Affixing the Adhesive Safety and Information
Labels .................................................................19
After Shearing Off...............................................67
Aligning the Cutter Bar........................................53
Angular gearbox ...........................................49, 50
Attached devices ................................................14
B
Before mowing....................................................36
Before the Start of the New Season...................72
Blade Changing on Cutting Discs.......................61
Blade Quick-Fit Device .................................57, 63
Blade screw connection......................................56
Blade Screw Connection ....................................62
C
Checking the Cutter Blades and Blade Holder...55
Checking the First fitting .....................................32
Commissioning ...................................................23
Compensation Spring(s).....................................41
Contact..................................................................7
Conversion for mowing steep slopes..................77
Conversion to narrower swathing .......................75
Cutter Blades......................................................55
D
Dangers in Case of Non-compliance with the
Safety Instructions ..............................................12
Detaching the machine.......................................38
Deviating Torque ................................................47
Driving and Transport .........................................34
F
Filling Quantities and Lubrication Designations for
Gearboxes ..........................................................48
First installation...................................................23
Fitting the guard cloths .......................................24
H
Hydraulic system ................................................16
I
Identification Plate ................................................8
Identifying Symbols in the Operating Instructions
............................................................................11
Inadmissible Modes of Operation.......................18
Information Required for Questions and Orders ..8
Install the PTO shaft .......................................... 31
Installation of Weiste triangle............................. 26
Intended Use........................................................ 9
Introduction .......................................................... 7
L
Lighting ........................................................ 27, 34
Lower suspension arm....................................... 29
Lubrication Chart................................................ 70
M
Maintenance ................................................ 17, 45
Maintenance – lubrication chart......................... 69
Mounting onto the Tractor.................................. 28
Moving the guards into the working position ..... 37
Mower Drive Gearbox.................................. 51, 52
O
Oil Level Check and Oil Change Intervals
(Gearboxes)....................................................... 48
Oil level check and oil change on the cutter bar 53
Operation ........................................................... 36
P
Periodical Inspection of the Cutting Discs / Blade
Drums................................................................. 59
Periodical Inspection of the Leaf Springs .......... 58
Personnel Qualification and Training................. 12
Placing in Storage.............................................. 71
Position of the Adhesive Safety Stickers on the
Machine ............................................................. 20
Preparation on the front-mounted disc mower .. 26
PTO operation.................................................... 15
PTO shaft..................................................... 30, 69
Purpose of Use .................................................... 7
R
Removing the compensation spring(s) .............. 38
Re-Ordering the Adhesive Safety and Information
Labels ................................................................ 19
Replacing the linings.......................................... 64
Rotary hub with shear fuse (optional)................ 65
S
Safety................................................................. 11
Safety Instructions and Accident Prevention
Regulations........................................................ 13
Safety-conscious work practices ....................... 12
Setting of the V-belt Tension ............................. 44
Settings.............................................................. 40
Spare Parts........................................................ 46
Special equipment ............................................. 74

Krone EasyCut F 360 Specifications

General

Brand	Krone
Model	EasyCut F 360
Category	Lawn Mower
Language	English