STORAGE 219
– Cover the motorcycle with a porous sheet or blanket.
Info
Do not use non-porous materials since they prevent humidity from escaping, thus causing corrosion.
Avoid running the engine for a short time only. Since the engine cannot warm up properly, the water vapor produced during
combustion condenses and causes valves and exhaust system to rust.
15.2Putting into operation after storage
– Take the front of the motorcycle off the work stand. ( p. 103)
– Take the rear of the motorcycle off the work stand. ( p. 104)
–
Recharge the battery. x ( p. 159)
–
Install the battery. x ( p. 158)
– Set the clock with SET CLOCK. ( p. 70)
– Fill up with fuel. ( p. 97)
– Make checks before putting into operation. ( p. 89)
– Make a test ride.
To Next Page
Loading...
Need help?
General
