2PX/2PY
1-4-51
(2-6) U011XX error code table: G3 reception
Error code Description
U01100 Function of the unit differs from that indicated by a DCS signal.
U01101 Function of the unit (excl. communication mode select) differs from that indicated by an
NSS signal.
U01102 A DTC (NSC) signal was received when no transmission data was in the unit.
U01110 No response after transmission of a DIS signal.
U01111 No response after transmission of a DTC (NSC) signal.
U01113 No response after transmission of an FTT signal.
U01125 No response after transmission of a CNS signal (between units of our make).
U01129 No response after transmission of an SPA signal (short protocol).
U01141 A DCN signal was received after transmission of a DTC signal.
U01143 A DCN signal was received after transmission of an FTT signal.
U01155 A DCN signal was received after transmission of an SPA signal (short protocol).
U01160 During message reception, transmission time exceeded the maximum transmission time
per line.
U01162 Reception was aborted due to a modem malfunction during message reception.
U01191 Communication was interrupted because an error occurred during an image data recep-
tion sequence in the V.34 mode.
U01193 There was no response, or a DCN signal or invalid command was received, during
phase C/D of reception.
U01194 A DCN signal was received during phase B of reception.
U01195 No message was received during phase C of reception.
U01196 Error line control was exceeded and a decoding error occurred for the message being
received.
To Next Page
Loading...
Need help?
General
