Kyocera ECOSYS M6026cidn User Manual

2PX/2PY
1-3-2
(2) Maintenance modes item list
Section
Item
No.
Content of maintenance item
Initial
setting
General U000 Outputting an own-status report -
U001 Exit Maintenance Mode -
U002 Setting the factory default data -
U004 Setting the machine number -
U010 Set Mainte ID -
U019 Firmware Version -
Initialization
U021 Memory initializing -
Drive,
paper
feed and
paper
conveying
system
U034 Adjust Paper Timing Data
LSU Out Top
LSU Out Left
600/0/0/0
600/0/0/0/0/0
Optical U065 Adjust Scanner Motor Speed 0/0
U066 Adjust Table Leading Edge Timing 0/0
U067 Adjust Table Center 0/0
U068 Adjust DP Scan Position 0/0
U070 Adjust DP Motor Speed 0
U071 Adjust DP Leading Edge Timing 0/0/0/0/0
U072 Adjust DP Original Center 0/12/0
Operation
panel and
support
equipment
U203 Checking DP operation -
U222 Setting the IC card type Other
Mode setting U250 Setting the maintenance cycle 200000
U251 Checking/clearing the maintenance count 0
U252 Setting the destination -
U253 Switching between double and single counts Double count
U260 Selecting the timing for copy counting Eject
U285 Setting service status page On
U332 Setting the size conversion factor 1.0 /0/1.0/2.5
U345 Setting the value for maintenance due indication 0
U346 Selecting Sleep Mode On/On

Kyocera ECOSYS M6026cidn Specifications

General

Brand	Kyocera
Model	ECOSYS M6026cidn
Category	All in One Printer
Language	English