8-1
Section 8 OPTIONAL EQUIPMENT
(1) Document Processor
The Document Processor automatically feeds one-sided originals one
by one for scanning. It also reverses two-sided originals automatically
for duplex copying and page separation copying.
11
11
1 Originals that can be used with the Document Processor
• Sheet originals only
•Original weights: Single-sided original of 35 g/m
2
to 160 g/m
2
two-
sided original of 50 g/m
2
to 120g g/m
2
•Original sizes: 11" x 17"/A3 (maximum) to 5 1/2" x 8 1/2"/A5R
(minimum)
• Capacity:
100 sheets (8 1/2" x 11"/A4 and smaller, 75 g/m
2
or 80 g/m
2
)
70 sheets (8 1/2" x 14"/Folio and larger, 75 g/m
2
or 80 g/m
2
)
30 sheets in auto selection mode
22
22
2 Precautions for the use of Document Processor
Do not use any of the originals given below with the Document
Processor. Also do not set originals with punch holes or tear-off strips
positioned at the leading edge.
•Transparency films
• Carbon paper and extremely creased or folded originals, originals of
sort material such as vinyl
• Non-square originals, wet originals, originals with adhesive tape or
glue
•Originals bundled with a paper clip or staple (if inevitable, remove
the paper clip or staple and straighten out the creases and folds
before setting the originals)
• Clipped out originals, originals with slippery surface
•Originals with still-wet whiteout
•Originals with creases (if inevitable, straighten out the creases
before setting the originals)
33
33
3 Document Processor part names
1 Original table
(Place the originals here.)
2 Original insertion guides
(Adjust the guides to the width of the originals.)
3 Document Processor open/close handle
(Hold this handle when opening and closing the Document
Processor.)
4 Original eject cover
(Copied originals are stored here.)
5 Document Processor original cover
(Open this cover to remove an original misfed in the Document
Processor.)
6 Original set indicator
(Lights green when the originals are set.)
1
2
5
To Next Page
Loading...
Need help?
General
