D9U001MC0-0101_1616
► Follow the instructions in the instructions for use carefully.
► Use the bed exclusively if it is in perfect working order.
► If necessary, check the bed functions daily or at each shift change.
► Ensure any user has read and understood this manual completely before operating the product.
► Use the bed exclusively with the correct mains supply.
► Ensure that the bed is operated exclusively by qualied personnel who have been trained according to the instructions for
use.
► Ensure that the patient (health permitting) has been informed about the operation of the bed and all applicable safety
instructions.
► Move the bed exclusively on even, hard-surfaced oors.
► Replace any damaged parts immediately with original spare parts.
► Ensure that maintenance and installation are performed exclusively by qualied personnel who have been trained by the
manufacturer.
► During peak loads or unavoidable excess loads (CPR), place mattress platform in the lowest position.
► Ensure that only one adult patient uses the bed at any time.
► Take care to avoid injuries or squeezing when operating moving parts.
► When using lifting poles or infusion stands, ensure that nothing will be damaged when you move or adjust the bed.
► Brake the castors when the bed is occupied.
► Keep the mattress platform in the lowest position at any time when the healthcare personnel are not trea- ting the patient
in order to prevent the patient from falling or injuries.
► Ensure that siderails are operated exclusively by healthcare personnel.
► Never use the bed in areas where there is a hazard of explosion.
► Enable or disable functions on patient controls using the Multiboard panel as appropriate for the patient’s physical and
mental state. Verify that the function is actually disabled.
► Never handle the mains plug with wet hands.
► Disconnect the product from the mains exclusively by pulling the mains plug.
► When pulling the mains plug, always hold the plug, not the cable.
► Position the mains cable so that there are no loops or kinks in the cable; protect the cable from mechani- cal wear and
tear.
► Improper handling of mains cable can cause an electric shock hazard, other serious injuries or damage to the mattress
replacement system.
► Ensure that the stipulated duty cycle (on-time) is not exceeded.
► Ensure that the moving parts of the bed are not blocked.
► To prevent failures, use exclusively the manufacturer’s original accessories and mattresses.
► Ensure that the stipulated safe working load is not exceeded.
► If the patient‘s condition could lead to an entrapment, leave the mattress support platform in the at position whilst
unattended.
► When adjusting the ALT (automatic lateral therapy), ensure that the process does not pose any risk of the patient falling or
getting injured, or of any lines or tracheal tubes getting pulled out.
► Adjust bed height to approx. 20 cm below maximum height when transporting the bed in order to facilitate overcoming
possible obstacles.
► Do not exceed maximum load of 80 kg for mattress platform extension.
► Ensure that the bed and its components are exclusively modied with the manufacturer´s approval.
► Use the mattress system exclusively as specied in this manual and in perfect working order.
► Use the mattress system exclusively with the correct mains supply.
► Use the mattress system exclusively in its original state and do not modify it in any way.
► Have the mattress system used exclusively by or under supervision of trained and qualied nursing per- sonnel.
► Have the mattress system serviced and installed exclusively by qualied personnel trained and authorised by the
manufacturer.
► Do not use the SCU near ammable gases.
WARNING!
Make sure the duty cycle (2 min ON/18 min OFF) is not exceeded during bed positioning!
WARNING!
Patient is allowed to use selected control elements only if hospital personnel had assessed that the patient´s
physical and psychological state is in accordance with use of them and only if the hospital personnel had
trained the patient in accordance with the instructions for use!
WARNING!
Hospital personnel is allowed to use the weighing system (scales) for weighing patients only if they had been
trained according to the instructions for use!
To Next Page
Loading...
Need help?
General
