Manitou MHT 7140 T-E3 User Manual

3-14
A5 - TYRES PRESSURE AND WHEEL NUTS TORQUE
CHECK
- Check the condition of the tyres, to detect cuts, protuberances, wear, etc.
- Check the torque load of the wheel nuts. Non compliance with this instruction can cause damage and rupture to the wheel bolts and
distortion to the wheels.
Wheel nuts tightening torque
• Front tyres: 630 N.m ± 15%
• Rear tyres: 630 N.m ± 15%
- Check and adjust the tyre pressures if necessary (see: 2 - DESCRIPTION: FRONT AND REAR TYRES).
Check that the air hose is correctly connected to the tyre valve before inflating and keep all persons at a distance during inflation. Respect the recommended
tyre pressures given.
NOTE: There is an OPTIONAL wheel toolkit and anti-puncture kit.
A6 - BOOM PADS
CLEAN - GREASE
To be carried out every 10 hours during the first 50 hours service, then once at 250 hours.
- Extend the boom completely.
- With a brush, apply a coat of grease (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) on the 4 sides of the telescope(s) (fig. A6).
- Telescope the boom several times in order to spread the coat of grease evenly.
- Remove the surplus of grease.
If the lift truck is used in an abrasive environment (dust, sand, coal…) Use lubricating varnish (MANITOU reference: 483536). In this respect, consult your
dealer.
A6

Manitou MHT 7140 T-E3 Specifications

General

Brand	Manitou
Model	MHT 7140 T-E3
Category	Lifting Systems
Language	English