2-72 Published 11-22-2016, Control # 345-12
HYDRAULIC SYSTEM RT9130E-2 SERVICE MANUAL
a. Clean the barrel and retainer ring with Loctite
cleaning solvent 7070 or similar non-chlorinated
solvent.
b. Apply a light coating of Loctite primer N7649 to both
surfaces. Allow primer to dry for one to two minutes.
Primer must be dry. Mating of parts should occur
within five minutes.
c. Apply gasket material Loctite Master Gasket 518 to
one surface. Partial cure is obtained in four hours,
with full cure in 48 hours.
13. Screw the head retainer ring into the barrel and align
holes in retainer ring with holes in head. Install and
tighten two socket head capscrews. Re-torque after
completion of cylinder hydraulic test procedure.
14. Using a spanner wrench or chain wrench, continue to
screw the retainer ring/head into place in the barrel.
15. Position the holding valve on the cylinder barrel and
secure with the capscrews and flatwashers. Connect
tubing to holding valve.
16. Pressurize and cycle the cylinder with hydraulic oil
pressure. Test the cylinder at 4500 psi (31026 kPa).
Check for proper operation and any leakage. Make
repairs as needed.
CAUTION
Flying Parts Hazard!
Use only a source of controlled hydraulic oil pressure to
cycle or pressurize the cylinder.
Parts can fly from the cylinder at dangerous speeds when
using air pressure.
To Next Page
Loading...
Need help?
General
