Grove Published 11-22-2016, Control # 345-12 8-3
RT9130E-2 SERVICE MANUAL UNDERCARRIAGE
3. Turn the wheels to the extreme right and repeat step 2
for the right side.
Rear Wheels Not Centered Switch
Adjustment Procedure
1. Ensure the wheels are straight ahead.
NOTE: Refer to (Figure 8-1) for rear wheels not centered
switch adjustment.
2. Ensure proximity sensor switch is centered in the slot of
the sensor plate bolted to the axle oscillation lockout
cylinder. Adjust by moving the sensor mounting bracket.
3. Ensure a maximum gap of 0.19 in (4.8 mm) exists
between the sensor switch and the sensor plate. Adjust
by loosening switch mounting bolts and moving switch
up or down on the mounting bracket. Tighten the
mounting bolts.
4. Turn the rear wheels to verify proper operation. Rear
Wheels Not Centered Lamp in cab should be out when
rear wheels are centered and the sensor switch is
centered in the slot of the sensor plate.
Item Description
1 Proximity Switch
2 Angle Bracket
3Sensor Plate
Item Description
To Next Page
Loading...
Need help?
General
