Matrix mvBlueFOX3 User Manual

12 GenICam and Advanced Features
12.1 Introduction
For new applications or to set the device via wxPropView we recommend to use the GenICam
interface layout as it allows the most flexible access to the device features.
After you've set the interface layout to GenICam (either programmed or using wxPropView), all
GenICam controls of the device are available.
Note:
It depends on the device, which controls are supported. To clarify if your device supports a
specific control or property, you can use the interactive Product Comparison chapter. Just
select the wanted property and click on the button "Rebuild Comparison Table".
In wxPropView, you can see them in "Setting -> Base -> Camera -> GenICam":
Figure 1: wxPropView - GenICam controls
As you can see, there are some controls with and without the prefix "mv".
"mv" prefix features are unique non-standard features developed by MATRIX VISION.•
101

Matrix mvBlueFOX3 Specifications

General

Brand	Matrix
Model	mvBlueFOX3
Category	Digital Camera
Language	English