Matrix mvBlueFOX3 User Manual

(SequencerSetSelector)
in the device even if
SequencerMode is off.
This will also change the
device state.
SequencerPathSelector SequencerPathSelector
Selects to which path
futher path settings
applies.
SequencerSetNext SequencerSetNext
Select the next
sequencer set.
SequencerTriggerSource SequencerTriggerSource
Specifies the internal
signal or physical input
line source which triggers
the sequencer (e.g.
FrameStart, Line0, etc.).
The sequencer mode can be used to set a series of feature sets for image acquisition. The sets can
consecutively be activated during the acquisition by the camera. The sequence is configured by a
list of parameters sets.
Note:
At the moment, the Sequencer Mode is only available for MATRIX VISION cameras with
CCD sensors. Furthermore:
- currently only the Exposure Time parameter is supported, with more features to follow
soon.
- conditional sequencer paths triggered by various sources and events are not supported
(you may refer to the GenICam SFNC 2.1 specification for further information).
- Sequencer sets are not saved in the User Sets at the moment.
Actual settings of the camera are overwritten when a sequencer set is loaded.
12.16 Transport Layer Control
The "Transport Layer Control" contains features like
Feature name (acc. to SFNC)
Property name (acc. to
mvIMPACT Acquire)
Description
PayloadSize payloadSize
Provides the number of
bytes transferred for
each image or chunk on
the stream channel.
GevVersionMajor gevVersionMajor
Major version of the
specification.
GevVersionMinor gevVersionMinor
Minor version of the
specification.
GevDeviceModeIsBigEndian gevDeviceModeIsBigEndian
Endianess of the device
registers.
GevDeviceClass gevDeviceClass
Returns the class of the
device.
12 GenICam and Advanced Features
120

Matrix mvBlueFOX3 Specifications

General

Brand	Matrix
Model	mvBlueFOX3
Category	Digital Camera
Language	English