Matrix mvBlueFOX3 User Manual

in between the nodes linear interpolation is used.
12.14.2 mvLUTInputData
This register describes on which data the LUT is applied to: Bayer means that the LUT is applied to
raw bayer data, thus (depending on the debayer algorithm) a manipulation of one pixel may also
affect other pixels in its neighborhood Gray means that the LUT is applied to gray data RGB means
that the LUT is applied to RGB data (i.e. after debayering). Normally this is used to change the
luminance on an RGB image and the LUT is applied to all three channels.
12.14.3 mvLUTMapping
This register describes the mapping of the currently selected LUT, e.g "map_10To10" means that a
10 bit input value is mapped to a 10 bit output values whereas "map_12To10" means that a 12 bit
input value is mapped to a 10 bit output value.
12.14.4 LUT support in MATRIX VISION cameras
-X100wG
-X100wG-POE
-X102bG
-X102bG-POE
-X102bG-POEI
-X102dG
-X102dG-POE
-X102dG-POEI
-X102eG
-X102eGE
-X104eG
-X104eG-POE
-X104eG-PLC
-X102eG-POE
-X102eGE-POE
-X102eG-POEI
-X102eGE-POEI
-X105G
-X120aG
-X120aG-POE
-X120bG
-X120bG-POE
-X120bG-PLC
-X120dG
-X120dG-POE
-X120dG-POEI
-X122G
-X122G-POE
-X122G-PLC
-X122G-POEI
-X123G
-X123G-PLC
-X123G-POE
-X123G-POEI
-X124G
Luminance Direct map_10To10 Gray
12 GenICam and Advanced Features
115

Matrix mvBlueFOX3 Specifications

General

Brand	Matrix
Model	mvBlueFOX3
Category	Digital Camera
Language	English