12.17 User Set Control
The "User Set Control" contains features like
Feature name (acc. to SFNC)
Property name
(acc. to
mvIMPACT
Acquire)
Description
UserSetSelector userSetSelector
Selects the feature User Set to load, save or
configure.
UserSetLoad[UserSetSelector] userSetLoad
Loads the User Set specified by
UserSetSelector to the device and makes it
active.
UserSetSave[UserSetSelector] userSetSave Endianess of the device registers.
UserSetDefault userSetDefault
Selects the feature User Set to load and
make active when the device is reset.
related to the User Set Control to save and load the user device settings.
The camera allows the storage of up to five configuration sets in the camera. This feature is similar
to the storing settings in the registry but this way in the camera. It is possible to store
exposure,•
gain,•
AOI,•
frame rate,•
LUT,•
one Flat-Field Correction ,•
etc.•
permanently. You can select, which user set comes up after hard reset.
Use case related to the "User Set Control" is:
Creating user set entries•
Another way to create user data is described here: Creating user data entries
12.18 mv Frame Average Control (only with specific
models)
The "mv Frame Average Control" contains features like
Feature name
(acc. to SFNC)
Property name (acc. to
mvIMPACT Acquire)
Description
mvFrameAverageEnable Enables the frame averaging engine.
mvFrameAverageSlope The slope in full range of register.
related to the frame averaging engine.
12 GenICam and Advanced Features
122