Matrix mvBlueFOX3 User Manual

Thirdly, if you know the number of image blocks, you can use the How to see the first image
MultiFrame functionality (in "Setting -> Base -> Camera -> GenICam -> Acquisition Control" set
"Acquisition Mode = MultiFrame" and "Acquisition Frame Count"). This will acquire the
number of image blocks and will stop the acquisition afterwards.
18.2.7 Working with Event Control
The mvBlueFOX3 camera generates Event notifications. An Event is a message that is sent to the
host application to notify it of the occurrence of an internal event. With "Setting -> Base -> Camera
-> GenICam -> Event Control" you can handle these notifications.
At the moment, it is possible to handle
Exposure End (= sensor's exposure end)•
Line 4 (= DigIn0) Rising Edge•
Line 5 (= DigIn1) Rising Edge•
Frame End (= the camera is ready for a new trigger)•
18.2.7.1 Setting Event notifications using wxPropView
To activate the notifications, just
Select the Event via "Setting -> Base -> Camera -> GenICam -> Event Control -> Event
Selector", e.g. ExposureEnd .
1.
Set the "Event Notification" to "On" .2.
Afterwards, it is possible to attach a custom callback that gets called whenever the property is
modified. E.g. if you want to attach a callback to the Frame ID after the exposure was finished, you
have to
select "Setting -> Base -> Camera -> GenICam -> Event Control -> Event Exposure End
Data -> Event Exposure End Frame ID",
1.
right-click on the property, and2.
click on "Attach Callback".3.
18 Use cases
166

Matrix mvBlueFOX3 Specifications

General

Brand	Matrix
Model	mvBlueFOX3
Category	Digital Camera
Language	English