Matrix mvBlueFOX3 User Manual

for consistency and activate
it. This will also update the
DeviceRegistersValid flag.
mvDeviceProcessingUnitSelector 0 0 1 -
Selects the device
processing unit.
mvDeviceProcessingUnit - - - mvFrameAverage
The processing unit to
activate for the selected
processing unit.
mvFrameAverage: Selects
the frame average engine for
this processing unit.
mvDevicePowerMode - - -
mvActive,
mvStandby
Selects the device power
mode.
mvActive: Puts the device to
power-active mode. Going
back to 'mvActive' will take
about 10 seconds.
Afterwards features will be
set to their default value, but
will NOT be invalidated. It is
recommended to re-open the
device to get consistent
register settings again.
mvStandby: Puts the device
in power-saving mode. In this
mode the device will only
consume up to 20 percent of
its normal power
consumption. Going back to
'mvActive' will take about 10
seconds.
DeviceLinkSelector 0 0 1 -
Selects which Link of the
device to control.
DeviceLinkSpeed 0 INT_MAX 1 -
Indicates the speed of
transmission negotiated on
the specified Link. (Bps)
DeviceLinkThroughputLimitMode - - - Off,
On
Controls if the
DeviceLinkThroughputLimit
is active. When disabled,
lower level TL specific
features are expected to
control the throughput. When
enabled,
DeviceLinkThroughputLimit
controls the overall
throughput.
Off: Disables the
DeviceLinkThroughputLimit
feature.
21 Appendix A.2 CMOS specific camera / sensor data
1920

Matrix mvBlueFOX3 Specifications

General

Brand	Matrix
Model	mvBlueFOX3
Category	Digital Camera
Language	English