IGNITION
Page 2A-36 90-883728 JULY 2001
Temperature Sensor Removal
ANALOG TEMPERATURE SENSOR
1. Remove screw and retaining plate.
2. Disconnect bullet connector and remove sensor.
DIGITAL TEMPERATURE SENSOR
1. Disconnect wire harness for PORT and STARBOARD sensors.
2. Unscrew sensor from cylinder head.
58893
a
b
c
d
e
e
f
g
a-Bullet Connector
b-Analog Temperature
Sensor
c-Retainer
d-Retainer Screw
e-Digital Temperature
Sensor
f-Port Sensor Harness
g-Starboard Sensor Har-
ness
Engine Head Temperature Sensor Installation
ANALOG TEMPERATURE SENSOR
1. Install sensor into pocket.
2. Secure sensor with retainer and screw. Ground (BLACK) lead of sensor is secured
with retainer screw. Torque retainer screw to 16.5 lb. ft. (22.4 Nm).
3. Reconnect sensor bullet connector.
DIGITAL TEMPERATURE SENSOR
1. Install sensors into cylinder heads. Torque sensors to 14 lb. in. (1.6 Nm).
2. Reconnect sensor harness connectors.
To Next Page
Loading...
Need help?
General