Technical Information
G600 & G800 Electronic Dishwashers
6.2.9 Width of Unit (As Applicable)
Some Electronic Units can be installed in more than one specific model
number; and therefore require programming the width of the
dishwasher it is being installed in. Refer to the model Specific
Programming / Service Modes Section for further details.
Note
To ensure proper appliance operation…The Electronic must be
programmed for the width of the dishwasher (Fullsize / Slimline) it is
installed in.
6.2.10 Flowmeter Count
Stores the “numeric value” marked on the side of the Flowmeter to
ensure proper operating conditions.
Note
To ensure proper appliance operation…The Flowmeter count must be
re-programmed after installation of a new Flowmeter and / or
Electronic.
6.2.11 Operating Hours
Records the duration (in hours) the appliance has been operated.
6.3 Programming / Service Modes - Access
Procedures
(Model Specific)
Refer to the Dishwasher Service Modes Guide;
included at the rear of this section.
100
To Next Page
Loading...
Need help?
General
