Before using for the first time
29
Basic settings
The following settings must be made
before starting up for the first time. You
can change these settings again at a
later time (see “Settings”).
Risk of injury caused by hot
surfaces.
The oven gets hot during operation.
For safety reasons, the oven may
only be used when it has been fully
installed.
The oven will switch on automatically
when it is connected to the electricity
supply. The display will show “Miele”
followed by a prompt to set the
language after a few seconds.
Setting the language
Use the rotary selector to select
the required language.
Confirm with OK.
If you have selected the wrong
language by mistake, proceed as
described in “Settings – Language ”.
Setting the location
Use the rotary selector to select
the desired location.
Confirm with OK.
Setting up Miele@home
Set up “Miele@home” will appear in the
display.
To set up Miele@home now, confirm
by touchingOK.
To set it up at a later date, selectSkip
with the rotary selector and
confirm withOK.
See “Settings – Miele@home” for
information on setting up at a later
date.
To set up Miele@home now, select
the desired connection method.
You will then be guided by the display
and the Miele app.
Setting the time of day
Set the time of day in hours and
minutes using the rotary
selector.
Confirm with OK.
Completing the initial commissioning
process
Set up finished will appear.
Confirm with OK.
Language will appear.
Select the sensor control.
The time of day appears.
Initial commissioning is now complete.