Supervisor level
100
Special programmes
You can put together five special resid-
ual moisture or time-controlled pro-
grammes and assign your own pro-
gramme names.
First, enter the programme name.
Select the special programme you
want to change.
The Save asmenu opens.
Use the letters and symbols below
the line to enter the name.
Touch the Savesensor.
You can now enter the parameters for a
Res. moisture programme or Timed
drying.
The five special programmes are pre-
programmed at the factory. You can
change these special programmes.
The special programmes are added to
the programme packages. Enter the
name and settings of your special pro-
gramme into the “Special pro-
grammes” table in the “Programme
overview” chapter.
Res. moisture programme
- Final residual moisture:
-6%(dry) – 40%(damp)
- Extra drying time:
0–60minutes
- Temperature (Process air):
cold – 70°C
- Drum rotation, main direction:
0–600seconds
- Drum reversal:
0–600seconds
- Holding phase
– Holding time:
0–60minutes
– Holding temperature (Process air):
cold – 70°C
- Cooling down temp. (Process air):
40–55°C
- Anti-crease
– Drum rotation, main direction:
0–500seconds
– Drum reversal:
0–500seconds
– Pause:
100–3000seconds
Timed drying
- Running time:
1–120minutes
- Temperature (Process air):
cold – 70°C
- Drum rotation, main direction:
0–600seconds
- Drum reversal:
0–600seconds
- Cooling down temp. (Process air):
40–55°C