Miele PDR 908 HP User Manual

Installation
*INSTALLATION*
83
Installation
Ensure that no closeable door, sliding
door, or an oppositely hinged door is
installed that would hinder the door
of the tumble dryer being opened in
any way.
Downtime after installation
 Damage caused by switching the
appliance on too soon.
This can damage the heat pump.
After setting up the tumble dryer,
wait for at least one hour before
switching it on.
Levelling the tumble dryer
The appliance must stand perfectly level
on all four feet to ensure safe and proper
operation.
The screw feet can be adjusted to com-
pensate for unevenness in the floor.
This tumble dryer is not suitable for
building under.
Never block the ventilation slots on
the tumble dryer. Do not block the
gap between the bottom of the
tumble dryer and the floor with plinth
facings, deep pile carpet etc. This
would hinder a sufficient flow of air to
the tumble dryer.

Miele PDR 908 HP Specifications

General

Door hinge	Left
Drum volume	130 L
Control type	Touch
Loading type	Front-load
Product color	Stainless steel
Built-in display	Yes
Custom panel-ready	No
Appliance placement	Freestanding
Drying system	Heat pump
Drying capacity	8 kg
Delay start (max)	24 h
Residual moisture	48 %
Spin-drying class	-
Maximum spin speed	- RPM
Noise level (drying)	- dB
Door opening angle	167 °
Current	10 A
Connected load	1440 W
Power plug type	Type F (CEE 7/4)
AC input voltage	220 - 240 V
AC input frequency	50 Hz

Weight and Dimensions

Depth	777 mm
Width	605 mm
Height	850 mm
Weight	72000 g
Package depth	820 mm
Package width	660 mm
Package height	940 mm
Package weight	78000 g
Door opening diameter	370 mm