Problem solving guide
73
Messages in the display
Message Cause and remedy
Open bottom right
grille, clean the heat
exchanger
The heat exchanger’s cooling fins behind the grille can
become blocked with dust and dirt drawn in from the
surrounding area and the airways can become
blocked with fluff.
Clean the heat exchanger. See “Bottom right grille/
heat exchanger” in “Cleaning and care”.
Check and clean the filters in the loading area and
in the plinth.
To delete the message: touch the OKsensor con-
trol.
Clean the fluff filter
and rinse the plinth
filter.
This information is displayed at the end of the pro-
gramme if the tumble dryer is not working correctly or
economically.
The fluff filters may be clogged.
Normally, all you have to do is clean the fluff filters.
Also check the plinth filter and clean it if necessary.
If you have removed the plinth filter, also check the
filter insert behind it. Clean the filter insert if ne-
cessary.
Please see “Cleaning and care” for notes on cleaning.
To delete the message: touch the OKsensor con-
trol.
Plinth filter not fitted.
Please fit it.
The plinth filter has not been inserted.
Check the filter in the plinth.
Removing the filter during a drying programme will
result in the programme being cancelled.
Power outage. Pro-
gramme stopped
There has been a power outage.
After resumption of power, confirm with OK.
Touch the Start/Stopsensor control.
Finish/Cool down There is no fault, but the drying process continues.
The laundry is still being cooled. The programme is
just about to end.
You can remove the laundry and spread it out to
cool down or leave it in the tumble dryer to cool
down until the end of the programme.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
