Miele PDR 908 HP User Manual

Problem solving guide
72
Message Cause and remedy
 Rinse the fluff filter
and the plinth filter.
Check the airways.
The plinth filter looks clean after thorough cleaning.
However, the programme is cancelled and the fault
message appears again. The reason for this is that
there is still underlying residue that cannot be re-
moved.
 To delete the message: touch the OKsensor con-
trol.
 Replace the plinth filter with a new one.
 You can reactivate the removed, “old” plinth filter in
the washing machine. Follow the instructions de-
scribed in “Problem solving guide – Reactivating
the plinth filter”.
 Check water drain-
age
The condensate drain is faulty.
 Check that the drain hose is in good working order
and is not bent.
 To delete the message: open and close the door
while the tumble dryer is switched on.
 Fault F. If restart
fails, call Service
There is no obvious cause for the cancellation of the
programme.
 Note the prompt in the display.
 Touch the OKsensor control.
 Start a drying programme.
If the programme is cancelled again with the same
fault message, then there is a fault. Contact the Miele
Customer Service Department.

Miele PDR 908 HP Specifications

General

Door hinge	Left
Drum volume	130 L
Control type	Touch
Loading type	Front-load
Product color	Stainless steel
Built-in display	Yes
Custom panel-ready	No
Appliance placement	Freestanding
Drying system	Heat pump
Drying capacity	8 kg
Delay start (max)	24 h
Residual moisture	48 %
Spin-drying class	-
Maximum spin speed	- RPM
Noise level (drying)	- dB
Door opening angle	167 °
Current	10 A
Connected load	1440 W
Power plug type	Type F (CEE 7/4)
AC input voltage	220 - 240 V
AC input frequency	50 Hz

Weight and Dimensions

Depth	777 mm
Width	605 mm
Height	850 mm
Weight	72000 g
Package depth	820 mm
Package width	660 mm
Package height	940 mm
Package weight	78000 g
Door opening diameter	370 mm