Miele PDR 908 HP User Manual

Cleaning and care
54
2. Cleaning the plinth filter
The filter in the plinth is behind the fluff
filter flap on the bottom left.
Normal use
Always clean the appliance whenever
prompted to do so in the display. Vari-
ous messages can be displayed:
Clean the fluff filter and rinse the plinth fil-
ter.
Rinse the fluff filter and the plinth filter.
Check the airways.
Continuous operation
Clean once a day and also when the
prompt appears in the display.
Cleaning the filter insert in the plinth
The filter insert is visible in the plinth
after removing the fluff filter. Clean the
filter insert as well.
 To delete the message: touch the
OKsensor control.
 Damage caused by insufficient
cleaning or by operation with a worn,
damaged filter in the plinth.
There is insufficient flow of air and
heat in the heat exchanger due to
clogging. This requires a visit from
the Service department.
This can be avoided by following the
advice in these operating instruc-
tions.

Miele PDR 908 HP Specifications

General

Door hinge	Left
Drum volume	130 L
Control type	Touch
Loading type	Front-load
Product color	Stainless steel
Built-in display	Yes
Custom panel-ready	No
Appliance placement	Freestanding
Drying system	Heat pump
Drying capacity	8 kg
Delay start (max)	24 h
Residual moisture	48 %
Spin-drying class	-
Maximum spin speed	- RPM
Noise level (drying)	- dB
Door opening angle	167 °
Current	10 A
Connected load	1440 W
Power plug type	Type F (CEE 7/4)
AC input voltage	220 - 240 V
AC input frequency	50 Hz

Weight and Dimensions

Depth	777 mm
Width	605 mm
Height	850 mm
Weight	72000 g
Package depth	820 mm
Package width	660 mm
Package height	940 mm
Package weight	78000 g
Door opening diameter	370 mm