Miele PDR 908 HP User Manual

Cleaning and care
63
Cleaning the filter insert (in the
plinth)
The surface of the filter in the filter in-
sert is visible after removing the fluff fil-
ter in the plinth. This filter surface must
only be cleaned if there is a visible accu-
mulation of fluff.
 Carefully vacuum up any visible fluff
or soiling. Use a dusting brush or the
narrow crevice nozzle.
If there are visible blockages or other
residues after cleaning: remove the
filter insert and clean it under running
water. If stubborn residues are not
removed, these can lead to faults
over time.
Removing the filter insert
If the filter insert is clogged up and
soiled, it must be removed and cleaned
under running water.
 Use the handle to pull out the filter
insert at an angle forwards and to the
right.
 Then pull the filter insert out at an
angle.
 Rinse the filter surface of the insert
under warm running water.
Wet filters could cause operational
faults while drying.
Shake the filter insert thoroughly and
then dry it carefully.

Miele PDR 908 HP Specifications

General

Door hinge	Left
Drum volume	130 L
Control type	Touch
Loading type	Front-load
Product color	Stainless steel
Built-in display	Yes
Custom panel-ready	No
Appliance placement	Freestanding
Drying system	Heat pump
Drying capacity	8 kg
Delay start (max)	24 h
Residual moisture	48 %
Spin-drying class	-
Maximum spin speed	- RPM
Noise level (drying)	- dB
Door opening angle	167 °
Current	10 A
Connected load	1440 W
Power plug type	Type F (CEE 7/4)
AC input voltage	220 - 240 V
AC input frequency	50 Hz

Weight and Dimensions

Depth	777 mm
Width	605 mm
Height	850 mm
Weight	72000 g
Package depth	820 mm
Package width	660 mm
Package height	940 mm
Package weight	78000 g
Door opening diameter	370 mm