To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...What to do if my Milton Roy Water Pump is making a pounding noise at high discharge pressure?
The pounding noise at high discharge pressure in the drive casing is due to fluid compressibility causing a reversal load on the gears at the end of the pressure stroke. This is not considered detrimental, so no action is needed.
Why does my Milton Roy mRoy B motor overheat and trigger thermal overload switches?
The motor overheats and triggers thermal overload switches for the following reasons: the power supply does not match the motor characteristics, so you should check the power supply against the motor nameplate data. Another reason might be overload caused by operating the pump above its discharge pressure, so you should check the operating pressure against the pump manufacturer’s data plate max. rating and correct the cause of the pressure abnormality.
What to do if my Milton Roy Water Pump delivery is not adjustable?
If your Milton Roy Water Pump delivery is not adjustable, consider the following: the flexible diaphragm may be punctured by foreign material, requiring you to replace the diaphragm; the O-rings on the control spool may be nicked, requiring you to replace the O-rings (note: you must use a special tool).
General| Brand | Milton Roy |
|---|---|
| Model | mRoy B |
| Category | Water Pump |
| Language | English |
Wear OSHA-approved protective clothing, face shield, safety glasses and gloves.
Guidelines for piping, suction lift, and NPSH requirements.
Steps for initial pump start-up, including torque checks, oil levels, and priming.
Regular maintenance like cleaning, leak checks, oil level checks, and valve replacements.
Symptoms and remedies for motor and pump capacity problems.
Detailed parts lists for mRoy A models, including motor mounts and liquid ends.
Detailed parts lists for mRoy B models, including motor mounts and liquid ends.
Guide to selecting model codes and understanding component options.
