Features and controls
3-171
3
The tire pressure monitoring system may not work normally in
the following circumstances:
● A wireless facility or device using the same frequency is
near the vehicle.
● Snow or ice is stuck inside the fenders and/or on the
wheels.
● The tire inflation pressure sensor’s battery is dead.
● Wheels other than Mitsubishi genuine wheels are being
used.
● Wheels that are not fitted with tire inflation pressure sen-
sors are being used.
● Wheels whose ID codes are not memorized by the vehicle
are used.
● Compact spare tire is fitted on a road wheel.
● A window tint that affects the radio wave signals is
installed.
OTE
● Tire inflation pressures vary with the ambient tempera-
ture. If the vehicle is subjected to large variations in ambi-
ent temperature, the tire inflation pressures may be under-
inflated (causing the warning light/display to come on)
when the ambient temperature is relatively low. If the
warning light/display comes on, adjust the tire inflation
pressure.
Whenever the tires and wheels are replaced with
new ones
N00532900179
If new wheels with new tire inflation pressure sensors are
installed, their ID codes must be programmed into the tire pres-
sure monitoring system. Have tire and wheel replacement per-
formed by an authorized Mitsubishi Motors dealer to avoid the
risk of damaging the tire inflation pressure sensors. If the
wheel replacement is not done by an authorized Mitsubishi
Motors dealer, it is not covered by your warranty.
CAUTION
!
● The use of non-genuine wheels will prevent the
proper fit of the tire inflation pressure sensors,
resulting in air leakage or damage to the sensors.
BK0138600US.book 171 ページ ２０１１年７月１７日 日曜日 午後２時３２分
To Next Page
Loading...
Need help?
General
