Adjusting the Volume
Procedure:
1 To increase the volume, press the Up arrow on the Volume Rocker.
2 To decrease the volume, press the Down arrow on the Volume Rocker.
Validating Compatibility During Power Up
When and where to use: The radio validates and updates the software and hardware of your control
head(s) during power up. During validation, the display shows Maintenance Mode Remote Device
promptly followed by other maintenance statuses.
Procedure:
Press the Power On/Off Button to reset when the display shows Update done Please
reset upon completion, or when the display shows Update failed Please reset when it
fails to update.
If the software updates are complete, the radio runs the usual power up operation.
If the updates are incomplete, the radio runs the Maintenance Mode and the display shows
Maintenance Mode Remote Device; promptly followed by other maintenance statuses again.
NOTICE: If SW incomplete appears, use Flashport Recovery Tool to update the control
heads before you power on the radio again.
6875946M01-JK
Preparing Your Radio for Use
22
To Next Page
Loading...
Need help?
General