3 INSTALLATION
20
Operational Check for the Remote Control
The operational check tests communication with the remote control:
Table 3-1 Operational check procedures
Feature Testing Procedure
Power on Press POWER on the remote control to turn on the DCH6416.
Tune to the output channel (3 or 4) if using the RF output.
Channel selection Scan through the channels using the CHANNEL + or - keys.
Tune to several channels by entering the channel number using the
numeric keys.
Volume control Press VOLUME + or - on the remote control to increase the volume to
its upper limit, lowest level, and to a comfortable level.
Press MUTE to turn the sound off. Press MUTE again to restore the
sound.
If the DCH6416 does not operate properly, refer to the Troubleshooting section.
Optimizing the High-Definition Settings
This subsection describes how to optimize SD and HD video settings and closed
captioning based on subscriber preferences.
Before you optimize the output settings:
• Connect the DCH6416 receiver to other home entertainment devices
• Plug the DCH6416 receiver into a power outlet
• Initialize the DCH6416 receiver and authorize services
• Turn the TV on
For an HDMI connection, be sure the TV is on and connected to the HDMI connector
before adjusting the settings. Motorola recommends using HDMI cables less than 20
meters long.
To optimize the output settings:
1. Power off the DCH6416 and then immediately press the
MENU key on the front
panel. If the TV is on, the on-screen menu lists the settings you can configure:
To Next Page
Loading...
Need help?
General
