4 DIAGNOSTICS
61
Interactive Status
This diagnostic describes the interactive information that is displayed only when Thin
Client platform is running. The information on the OSD and front panel is updated at
least once every 5 seconds while the diagnostic is displayed. This is an example of a
code module display with status descriptions:
Figure 4-10 Interactive status front panel display
The Interactive Status fields are:
Field Description
IP Address The IP address in dotted-decimal format xxx.xxx.xxx.xxx assigned by the NC 1500 to the
DCH6416. 0.0.0.0 is displayed if the IP address is not configured or unknown.
UPM The upstream modem address value is the same as the terminal ID assigned by the
DAC 6000. It is a unique, system-generated, eight-digit integer between 1 and 16777215.
00000000 is displayed when the UPM is not configured or if it is unknown.
Upstream ID A four-digit decimal value from 0000 to 9999 assigned by the DAC 6000 to the DCH6416.
0000 is displayed if the Upstream ID is not configured or if it is unknown.
Downstream
ID
A four-digit decimal value from 0000 to 9999 assigned by the DAC 6000 to the DCH6416.
0000 is displayed if the Downstream ID is not configured or if it is unknown.
State The interactive status of the DCH6416:
Front
panel
OSD Description
U UNCONFIG The DCH6416 is not configured for the interactive system,
and the platform should run as pre-interactive.
C MAC_CONNECT The DCH6416 is waiting to establish connection to MAC PID
Stream.
To Next Page
Loading...
Need help?
General
