Restoring Site Data
5-4 ◆ Section 5: Maintenance Options and SMDR DS2000 Hardware Manual
Restoring Site Data
Restoring Site Data from a PC Card
To use the PC Card to restore site data:
Review PC Card Data Base Compatibility on page 5-1.
1. Insert the PC Card into the CPU (See Using the PC Card on page 5-2).
2. Be sure the CPU mode switch is set to RUN.
3. Enter the programming mode.
ICM + #*#* + 372000 + HOLD
4. Dial 9907 + HOLD.
You see: START?
5. Dial Y + HOLD.
You see the name and date of the first database stored. If no data bases are stored, you see:
9907: DB00
(empty)
6. Press VOL ▲ or VOL ▼ to scroll through the data base addresses and select the one you want to restore.
There are 16 data base addresses (DB 00 to DB 15).
7. When the data base you want to restore displays, press HOLD.
The PC Card Active LED is on during restore.
You automatically exit programming when the upload completes.
PC Card Restore Error Messages
PC Card Restore Error Messages
This error message: Means this:
NO PCCARD The PC card is not installed. Install the PC
card and try again.
NO DATABASE There is no data stored in the data base address
you selected. Select another data base address
and try again.
To Next Page
Loading...
Need help?
General
