NEC MultiSync XG110LC User Manual

118
1 15 to 25 15kHz (60Hz)
2 20 to 40 NONE
3 35 to 50 48KHz (60Hz)
4 45 to 75 NONE
5 70 to 110 NONE
6 105 to 135 NONE
The feature allows you to view the default data stored in Default Area.
To view the data, proceed as follows:
1 Press the ADJUST button to display the “ADJUST” menu.
• The projector may ask you to enter your passcode.
See page 59 for the explanation of the PASSCODE.
2 Use the CURSOR or button to highlight the “8/OPTION”
line. Press ENTER to display the “OPTION” menu. You can also
select the “OPTION” menu directly by pressing the INPUT “8”
button.
3 Use the CURSOR or button to highlight the “7/DEFAULT
DATA” line. Press ENTER to display the “DEFAULT DATA”
screen. You can also select the “DEFAULT DATA” screen directly
by pressing the INPUT “7” button.
4 To complete, press the END button.
• Whenever the END button is pressed, the menus will sequence in
this order:
“OPTION” menu → “ADJUST” menu → Source screen
• If the “RETURN USER MODE?” menu appears, use the
CURSOR or button to select either “YES” or “NO” and
press ENTER. This will exit the ADJUST mode.
Items to select
• YES ......... When you try to enter the ADJUST mode the next
time, you will need to re-enter your passcode.
• NO ........... When you try to enter the ADJUST mode the next
time, you will not need to re-enter your passcode.
4 To exit the HOUR METER display, press END.
• Whenever the END button is pressed, the menus will sequence
in this order:
“ADJUST” menu → Source screen
• If the “RETURN USER MODE?” menu appears, use the
CURSOR or button to select either “YES” or “NO” and
then press ENTER. This will exit the ADJUST mode.
Items to select
• YES ......... When you try to enter the ADJUST mode again,
you will need to re-enter your passcode.
• NO ........... When you try to enter the ADJUST mode again,
you will not need to re-enter your passcode.
RETURN USER MODE?
YES NO
Viewing Default Data
– ADJUST –
1 / SIGNAL ENTRY
2 / FOCUS
3 / ALIGNMENT
4 / CONVERGENCE
5 / KELVIN
6 / R,G,B GAIN
7 / PASSCODE
8 / OPTION
9 / REF.ADJUST
– OPTION –
1 / SETTING MODE
2 / MENU MODE
3 / SEQUENCER
4 / PJ ADDRESS
5 / VERSION
6 / HOUR METER
7 / DEFAULT DATA

OPTION -DEFAULT DATA-
INPUT
H-FREQ. (KHz)
REGISTERED
DEFAULT DATA
RETURN USER MODE?
YES NO
SETTING

NEC MultiSync XG110LC Specifications

General

Brand	NEC
Model	MultiSync XG110LC
Category	Monitor
Language	English