NEC MultiSync XG110LC User Manual

84
SETTING
Automatic Save Feature
This feature allows you to select two ways to store settings; auto-
matically and manually.
After “ENABLE” is selected in the AUTOMATIC DATA STORE
menu, all projector settings are stored in the projector's memory
automatically. To set the AUTOMATIC DATA STORE, proceed as
follows:
1 Press the ADJUST button to display the “ADJUST” menu.
• The projector may ask you to enter your passcode.
See page 59 for the explanation of the PASSCODE section.
2 Use the CURSOR or button to highlight the “8/OPTION”
line and then press ENTER to display the “OPTION” menu. You
can also select the “OPTION” menu directly by pressing the
INPUT “8” button.
3 Use the CURSOR or button to highlight the “1/SETTING
MODE” line. Press ENTER to display the “SETTING MODE”
menu. You can also select the “SETTING MODE” menu directly
by pressing the INPUT “1” button.
4 Use the CURSOR or button to select the “AUTOMATIC
DATA STORE” item on Page 2, then press ENTER to display
the “AUTOMATIC DATA STORE” menu.
NOTE: The SETTING MODE has three menus. The “AUTOMATIC
DATA STORE” item is on the second menu (P02). To access
P02 from P01, press and hold down the CTL button then press
the button ; to return to P01 from P02, press and hold down
the CTL button then press the button.
– ADJUST –
1 / SIGNAL ENTRY
2 / FOCUS
3 / ALIGNMENT
4 / CONVERGENCE
5 / KELVIN
6 / R,G,B GAIN
7 / PASSCODE
8 / OPTION
9 / REF.ADJUST
– OPTION –
1 / SETTING MODE
2 / MENU MODE
3 / SEQUENCER
4 / PJ ADDRESS
5 / VERSION
6 / HOUR METER
7 / DEFAULT DATA
P02/P03
OPTION – SETTING MODE –

WARM-UP MODE
INACTIVE
OFF
SIGNAL SWITCHING SOUND
MUTE ON
PICTURE
MUTE ON
INACTIVE
DISABLE
AUTO POWER ON MODE
PHOSPHOR SAVER
AUTOMATIC DATA STORE

NEC MultiSync XG110LC Specifications

General

Brand	NEC
Model	MultiSync XG110LC
Category	Monitor
Language	English