NEC MultiSync XG110LC User Manual

94
SETTING
There are two modes of operations for the on-screen display. With
AUTO mode, the on-screen display will automatically switch off
after three through ten seconds. In the MANUAL mode, the display
must be manually turned off with the DISPLAY button on the full
function remote control each time it appears.
NOTE: Pressing DISPLAY with CTL will select the non on-screen
mode; pressing DISPLAY with CTL again will cancel this mode.
Even if the on-screen display may be turned off with CTL and
DISPLAY, any adjustment will still change the projector’s memory
settings.
Proceed as follows:
1 Press the ADJUST button to display the “ADJUST” menu.
• The projector may ask you to enter your passcode.
See page 59 for the explanation of the PASSCODE.
2 Use the CURSOR or button to highlight the “8/OPTION”
line. Press ENTER to display the “OPTION” menu. You can also
select the “OPTION” menu directly by pressing the INPUT “8”
button.
3 Use the CURSOR or button to highlight the “2/MENU
MODE” line. Press ENTER to display the “MENU MODE”
menu. You can also select the “MENU MODE” menu directly by
pressing the INPUT “2” button.
4 Use the CURSOR or button to highlight the “MESSAGE
MODE” item.
Press ENTER to display the “MESSAGE MODE” menu.
– ADJUST –
1 / SIGNAL ENTRY
2 / FOCUS
3 / ALIGNMENT
4 / CONVERGENCE
5 / KELVIN
6 / R,G,B GAIN
7 / PASSCODE
8 / OPTION
On-screen Display Mode Setting
– OPTION –
1 / SETTING MODE
2 / MENU MODE
3 / SEQUENCER
4 / PJ ADDRESS
5 / VERSION
6 / HOUR METER
7 / DEFAULT DATA
OPTION - MENU MODE -
MESSAGE MODE
MESSAGE COLOR
DATE, TIME DISPLAY
DATE, TIME PRESET
DATE : MM/DD/YY
TIME : 24HOUR
AUTO
COLOR
DATE : ON
DAY : OFF
TIME : ON
10 SEC
PJ ADDRESS DISPLAY
OFF
NEW SIGNAL MESSAGE
ON

NEC MultiSync XG110LC Specifications

General

Brand	NEC
Model	MultiSync XG110LC
Category	Monitor
Language	English