Configure Switching
109
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
6. Select the GVRP Mode Disable or Enable radio button.
This selects the GARP VLAN registration protocol administrative mode for the switch.
The default is Disable.
7. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Configure GARP Ports
Note: It can take up to 10 seconds for GARP configuration changes to take
effect.
 To configure GARP ports:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switchingï€ > VLAN > Advanced > GARP Port Configuration.
To Next Page
Loading...
Need help?
General